Lumasense-technologies Pearl Control Manuel d'utilisateur télécharger pdf (Page 42)

Pearl Control Software Manual Troubleshooting  42

Degraded Image

Quality

If the camera had a good image but the quality degraded after some

time, the most common cause is a lack of camera calibration. To maintain

a high quality image, the camera needs to calibrate itself periodically.

However, this automatic calibration can be turned off, and often leads

degraded image quality.

The automatic calibration setting can be found in the lower-right corner

of the Video tab:

Alternatively, you can correct the image manually by navigating to

Shortcuts > Correct Image:

No Image 1. Check that the camera is powered on.

2. Check the video cable.

3. Change the video brightness and contrast to All Automatic.

4. Change the Automatic Mode Setting to Minimum Bias.

These two settings should result in a video single in a visible range.

Unable to see

Calibrate

Tab/Unable to use

Reset Camera

The Calibrate tab is hidden by default.

1. Click Help > Advanced.

2. Enter the password: engineer.

3. Click OK or press enter.

1 2 ... 37 38 39 40 41 42 43 44

Pas de commentaire

Lumasense-technologies Pearl Control Manuel d'utilisateur Page 42