Lumasense-technologies Pearl Control Manuel d'utilisateur télécharger pdf (Page 25)

Pearl Control Software Manual Using Calibrate Tab Features  25

4. Click on the Signal Section.

5. In the Integration Time section, you can either enter the desired value in the text box

or use the slider bar to set the value.

6. Check the Status in the Information Bar to ensure the message “Updated integration

time” appears.

4.2.2 Gain

Gain adjusts the amount of gain used on the camera. Similar to Integration Time, increasing the

gain value will increase the amount of signal the camera receives.

Note: High values can result in increased noise and can cause the image to saturate.

To adjust the gain value:

1. Click Help and select Advanced from the drop down menu.

2. Enter the password: engineer

3. Click on the Calibrate Tab.

4. Click on the Signal Section.

5. In the Gain section, you can either enter the desired value in the text box or use the

slider bar to set the value.

6. Check the Status in the Information Bar to ensure the message “Updated detector serial

word” appears.

Slider Bar

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Pas de commentaire

Lumasense-technologies Pearl Control Manuel d'utilisateur Page 25