Lumasense-technologies M310 Manuel d'utilisateur télécharger pdf (Page 19)

M310 Manual Communications Port  19

Controller response:

%0101R0902.000N8<CR>

Command line to change blackbody setpoint to 30C:

$0101W0930.000F5<CR>

Controller response:

%0101w100K2<CR>

Note that bold characters above represent the Checksum Actual characters may be different

due to the calculation of checksum. Refer to the Appendices for a subroutine that calculates

checksum for each writing string. Also note that checksum must be used in all communications.

In the Appendices is a typical QBASIC program that reads current temperature and increments

setpoint at 10 °C intervals:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

Pas de commentaire

Lumasense-technologies M310 Manuel d'utilisateur Page 19