Lumasense-technologies ISR 6-TV Advanced Manuel d'utilisateur télécharger pdf (Page 19)

Series 6 – TV Advanced Manual Data format UPP · 19

6 Data format Universal Pyrometer

Protocol (UPP): Extended for Video

Module

Software commands can be exchanged directly with the pyrometer through an interface using

suitable communication software or by using the Test function located in the Pyrometer

Parameters window of the InfraWin software package.

The data exchange occurs in ASCII format with the following transmission parameters:

• The data format is: 8 data bits, 1 stop bit, even parity (8,1,e) no handshake;

• The device responds to the entry of a command with output (such as the measuring

value) + CR (Carriage Return, ASCII 13), to pure entry commands with ok + CR, or no +

CR.

• Every command starts with the 2-digit device address AA (e. g. "00"). This is followed by

1 lower case command letter and 2 numbers finished with CR.

Example Read Command: Entry: “00v08“ + <CR>

Selectable parameter that is additionally shown to the measuring temperature

Read selection: Answer: 2-digit, hex

e.g. "02" + <CR> The measured distance is displayed in addition to temperature.

o The ASCII parameter “X” indicates a change to be made in a parameter. When used, the

command contains the new value.

Example Write Command: Entry: “00v08XX “ + CR

The case temperature is additionally shown to the measuring temperature. A „?“

after the read command answers with the limits of the respective settings (only a

setting command, not a query command).

o A “?” after the lower case command letters answers with the limits of the respective

settings (only at setting commands, not at query commands).

Example Read Limits Command: Entry: “00v08?“ + CR!

The answer is "00FF" + <CR>

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 25

Pas de commentaire

Lumasense-technologies ISR 6-TV Advanced Manuel d'utilisateur Page 19