Lumasense-technologies IS 50-LO plus Manuel d'utilisateur télécharger pdf (Page 15)

IS 50-LO plus / IGA 50-LO plus Manual Controls and Installation  15

3.1.3 Connection of additional analyzing devices

Additional analyzing instruments (such as LED digital display instruments) only need to be

connected to a power supply and the analog outputs from the pyrometer. Another Instrument,

such as a controller or printer, can be connected to the display in series as shown below (total

load of resistance max. 500 Ohm).

yellow

LED digital display

Controller

Power supply

green

brown

white

230 V ~

24 V DC

°C

Writer

Converter

3.2 Mechanical Installation

3.2.1 Overview

3.2.2 Converter

To fix the converter, 2 drill holes for

screws with 4 mm diameter

accessible after removing the cover.

For fixing and aligning the optical

head, different mounting supports

are available (see 2.6 Accessories

(option)).

3.2.3 Fiber

The transmission between optical head

and converter is done via 0.2 mm (red

fiber mark) mono fiber with a stainless

steel protection hose (exceptions:

IS 50-Si-LO plus, MB 13: 0.4 mm mono

fiber (blue mark) and IS 50-Al-LO plus:

0.6 mm mono fiber (green mark)). The

optical head contains only the lens, the

sensor and the electronics are located

in the converter. Fiber and optical head

can be used in ambient temperatures

up to 250 °C without additional cooling (fiber at converter side max. 125 °C).

Cover

Drill holes

Fibre

Screw connection

Cut

out

Red mark

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Lumasense-technologies IS 50-LO plus Manuel d'utilisateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Lumasense-technologies IS 50-LO plus