Lumasense-technologies IGA 6/23 Advanced Manuel d'utilisateur télécharger pdf (Page 39)

IGA 6/23 Advanced Manual Data format UPP

· 39

Description Command Parameters

Read Parameters Aapa Answer: 15 decimal digits

DD............. : Emissivity (see em)

..D............ : Response time (see ez)

...D........... : Clear peak memory (see lz)

....D.......... : Analog output (see as)

.....DD........ : Internal temperature (see gt)

.......DD...... : Device address (see ga)

.........D..... : Baud rate (see br )

..........01000

: Fixed value

Serial number AAsn Output: XXXXX (hex 5-digit)

Device type /

Software version

AAve Answer: VVMMJJ VV=27

MM=Month JJ = Year of software version

Communication

Module/ software

version in detail

AAvc tt.mm.jj XX.YY

tt = day; mm = month; jj = year;

XX.YY = Software version

Software version in

detail

AAvs tt.mm.jj XX.YY

tt = day; mm = month; jj = year;

XX.YY = Software version

Note: the letter “l” means the lower case letter of “L”.

Additional instruction for the RS485 interface:

Requirements to the master system during half-duplex operation:

1. After an inquiry, the bus should be switched into a transmission time of 3 bits (some

older interfaces are not fast enough for this).

2. The pyrometer's response will follow after 5 ms, at the latest.

3. If there is no response, there is a parity or syntax error and the inquiry has to be

repeated.

4. After receiving the response, the master has to wait at least 1.5 ms before a new

command can be entered.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46

Pas de commentaire

Lumasense-technologies IGA 6/23 Advanced Manuel d'utilisateur Page 39