Lumasense-technologies IGA 320/23 Manuel d'utilisateur télécharger pdf (Page 21)

IMPAC pyrometer IGA 320/23

Internal temperature: AAgt

Output: XXX (dec. 000 ... 099°C, 032 ... 210°F)

Max. internal

temperature:

AAtm Output: XXX (dec. 000 ... 099, always in °C)

Limit switch SP1: AAs1XXXX

XXXX = set Limit switch, hex 4-digit, °C or °F

Mode

Limit switch SP1:

AAt1X

X = 0 Limit switch Off

X = 1 Limit switch close above

X = 2 Limit switch close below

Hysteresis

Limit switch SP1:

AAhlXX

XX = set hysteresis, hex 2-digit, °C or °F

Error status: AAfs Output: XX;

XX=00…FF (00 = no error)

(01…FF: error code for LumaSense service)

LED aiming light: AAlaX

X = 0 switch off aiming light

X = 1 switch on aiming light

LED aiming light at

Power-on

AAlpX

X = 0 aiming light off at Power-on

X = 1 aiming light on at Power-on

Reading parameters: AApa Output 11-digit, decimal:

Digit 1 und 2 (10...99 or 00): Emissivity

Digit 3 (0 ... 6): Exposure time

Digit 4 (0 ... 8): Clear time max. / min. value storage

Digit 5 (0 ... 1): Analog output

Digit 6 und 7: (00 ... 98): Internal temperature

Digit 8 und 9 (00 ... 97): Address

Digit 10 (0 ... 6 or 8): Baud rate

Digit 11 always 0

Device type: AAna Output: “IGA 320” (16 ASCII-characters)

Serial number: AAsn Output: XXXXX (dec. 5-digit)

Device type /

software version:

AAve Output: XXYYZZ (6-digit decimal)

XX = 56 (IGA 320)

YY = Month of software version

ZZ = Year of software version

Detailed Software

version:

AAvs tt.mm.yy XX.YY

tt = day; mm = month; yy = year; XX.YY = software version

Reference number: AAbn Output: XXXXXX (hex 6-digit)

Note: the letter “l” means the lower case letter of “L”.

Additional instructions for the RS485 interface:

Requirements to the master system during half-duplex operation:

1. After an inquiry, the bus should be switched into a transmission time of 3 bits

(some older interfaces are not fast enough for this).

2. The pyrometer's response will follow after 5 ms at latest.

3. If there is no response, there is a parity or syntax error and the inquiry has to be repeated.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Lumasense-technologies IGA 320/23 Manuel d'utilisateur Page 21

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Lumasense-technologies IGA 320/23